The mold temperature should be set to be higher than the condensation temperature in the injection molding area, which will prevent the contamination of the mold by moisture and the occurrence of streaks on the surface of the product. Higher mold temperat

Silicone and TPE can both provide materials suitable for hardness, finding a balance between facial contact comfort and material strength. currently, soft rubber TPE and silica gel used in gas masks usually have hardness of 45 ~ 50 a. at the same time, TP

TPE gas mask material base material is SEBS, which is a new type of environmental protection material and can pass through EU RoHS and REACH for environmental protection. Since SEBS itself does not contain protein components, the TPE gas mask m...

Firstly, TPE based on SEBS has better yellowing resistance than TPR based on SBS. Another is to choose good filling oil; Some UV-resistant and antioxidant can be added to the formula.

Why are some TPE wires not firmly bonded to the plug? TPE wire and plug are usually bonded by wrapping adhesive. If the wrapping adhesive is not firm, the bonding between wire and plug will not be firm. Therefore, the source of the problem starts from the

For some TPE products, precipitation often occurs. What are the common precipitation forms? What are the reasons? Next, the editor will explain to you about the precipitation of TPE products, hoping to help you.

TPE is a kind of polymer material, which is environment-friendly and non-toxic and widely used. In recent years, TPE has been favored by a large number of product manufacturers. Of course, there will also be some problems. For example, a friend recently a

With the more and more extensive application of TPE materials, in recent years, many related enterprises have established themselves at home and abroad. However, many people do not know much about the hardness of TPE and cannot control it, thus causing a