0-5 degree simulation bait TPE soft rubber material is comfortable, soft and transparent TPE - Environmental protection non-toxic TPE

0-5 degree simulation bait TPE soft rubber material is comfortable, soft and transparent TPE

The hardness of 0 degree TPE material is tested by Shore C. The greater the data, the softer the hardness of the material. We will also use 0 to represent, one 0 represents 0 degrees, up to 8 0 ultra-soft TPE materials. The 0 degree material is usually transparent or semitransparent particles, nontoxic and odorless. Has excellent elongation up to 1500%. The handle of 0 degree TPE material is close to that of silica gel. Generally, injection molding or pouring are used to produce sex toys, toys, gel cushions and automobile anti-skid cushions. Dechuang Chemical is a well-known domestic supplier of sex toys. High transparency TPE8 degrees, 10 degrees, 12 degrees, 0 degrees. Emulated skin, tasteless and oily. High transparency can reach 98%. It can also produce skin color, high extensibility and excellent resilience, high tensile property, good fluidity and yellowing resistance. It can replace silica gel /PVC material without odor, oil and spray. Non-toxic and environment-friendly meet the environmental testing standards of ROHS,REACH,PAHS,EN71, etc. The injection efficiency of 0 degree TPE is relatively low, because the hardness is too low, and the processed products shrink greatly, with shrinkage rate of 1.6~2.0%. Water lines will appear on the surface. It is recommended that the injection temperature be 120-150 degrees Celsius. The particles of 0 degree materials are all sticky, and feeding difficulties will occur in the production process. We suggest that injection molding manufacturers reduce the temperature in the blanking port area and adopt press-type auxiliary feeding, such as pressing down with a stick, which is directly effective. It is also possible to install a forced feeder with high rotating speed and low feeding mode. The heating section of the blanking area is closed. The injection temperature of 0 degree TPE material depends on SEBS molecular weight of TPE material. TPE modified by high molecular weight SEBS has high injection processing temperature, while TPE modified by low molecular weight SEBS has lower injection temperature. In addition, it is also related to the processing structure and mold design and the type of injection molding machine. If the product structure and mold design require high fluidity of materials, the injection molding processing temperature needs to be increased. If our order for 0 degree TPE material lasts for a long time, we can reform the injection molding machine. For example, the blanking port is enlarged, the charging barrel is reformed, and the screw rod is newly assembled. All these will improve the processing efficiency. Dechuang Chemical's TPE base material SEBS for sex toys has all been selected from Japan Kolali or US Koten. Dongguan Dechuang Chemical Co., Ltd. is a rubber and plastic raw material manufacturer specializing in the production of elastomer TPE/TPR/TPU/TPE/TPV. Dechuang Chemical has its own factory and research and development team, and has strong ability to develop new products. We will serve you wholeheartedly if there are any questions about thermal statue elastomer materials!